HelloDoes anyone knows, will LightBurn works with Ruida RDC8445S ?I try trial version, and Ruida always in disconnected state, Serial USB/Ethernet IP both not works.PS: RDWorks detect controller by USB and IP (WiFi) - both success 

96DED7E9

05-15

426

4

0

Hello, I'm upgrading an oscillating knife cutting machine. The machine had a Galileo controller. The PC used to operate it lost its hard drive. I couldn't configure the software from the backup I had.I purchased a Ruida RDD6616u controller from Wavetopsign on Aliexpress. I asked them for the installation manual and software on several occasions. I ...

Geozapata

06-14

171

4

0

Hello, we have a Ruida controller RDC6563FG for fiber laser cutter. Everything now works fine, except I can't change axis working speed parameters. In the service menu I'm trying to change the parameter Max. work speed, I've entered e.g. 2000 mm/s for axis movements speed. In the USER menus the max manual movement 500mm/s. Above these limits I can'...

Elektron

06-19

145

0

0

I use a new Monport 80w camera with RDC6442G.However, I hit autofocus in Lightburn or the Z-axis menu and the camera breaks. (This camera does not have a Z-axis limit switch).Can I disable the autofocus feature in the control panel or machine settings?I looked at the Ruida manual but it didn't help much with this problem.

ElenaXavier

05-15

508

1

1

This is a magic of ruida controller

S A Designs

2024-11-02

480

2

2

Hi,I have a RDC6563FG-LITE and the Manual is only in chinese and has not been translated to EN, I have used a translating service to translate the PDF but the translation is lacking and I have some questions about the controller.2.4 - RS232 The RS232 serial port is mainly used to control fiber lasers. The interface definition is as shown in the fol...

Juan Barkhuizen

2024-04-29

579

4

0

Hello!I can't adjust the gas pressure regulator.in the setting, the slok costs 1MPa. ITV2030 shows 0.75MPa.Can you tell me how to do the same?

Pavel_TT

2023-07-10

763

5

0