My engraving machine moves in one direction, how can I set it up?

ElenaXavier

Categories:

Ruida

432

See translation

05-27

I am a novice, I tried to use an engraving machine to carve some patterns, but I found that the engraving machine did not carve in the correct direction of the pattern, but in the wrong direction. How can I change the setting? I use RDWorksV8 software

96DED7E9

05-27
```
Check in Config --- Settings that the print head position is not Mirrored  
```
See translation

2

Reply
- ElenaXavier
  
  : Thanks a lot, it's working now,

Relevant recommendations

Collect

Report

My engraving machine moves in one direction, how can I set it up?

RDC6563FG

Press Z-axis to move manually on the panel, and the cutting head does not move

The panel did not prompt hard limit protection when Z-axis reached the hard limit switch

Once powered on, the cutting head will always move upward, and will not stop. Switch to the manual state, and the motor can be controlled to move, and then switch to the automatic mode, and always mov

How to adjust the step distance of Axis Z.