RDC6563FG-LITE
Categories:
Ruida
43
4
0
04-29
C
blue sea
04-29According to the question you described, the reply is as follows: 1. 2.4 - RS232 This is the wireless handle product of Ruida company, and the RS232 serial port is mainly used to connect the wireless handle to control the fiber laser. 2. The type of driver brand on the manual is for reference, and the specific needs to be subject to the suggestions provided by the equipment manufacturer.
1Reply-
: Hi thank you for your response, I am aware of the RS232 for the wireless handle but there is another RS232 labeled terminal with only 3 ports which can be seen top right in the picture of the unit, and the Port for the wireless handle is at the bottom right of the board. If it is not important I can leave it disconnected, but it is just a little confusing.
-
: The RS232 port in the upper right corner is reserved to set the peak current frequency, etc., to avoid the use of individual lasers that are not supported.
-
: Awesome thank you.
-
Relevant recommendations
- 2022-12-10
-
Controller Fault?
2 Replies08-02 - 05-31
- 2023-03-02
- 2022-12-10