My 40-50W co2 laser cuts 1/4" plywood and acrylic well at 50% but above 50%, the cuts get shallower as I increase the power. The current stays approximately proportional to the power setting, but the beam seems to get weeker. Is this normal or a sign of a partucular failure?The tube has less than 100 cutting hours, mostly at about 45%. I almost nev...

Miller

2023-02-27

431

1

0

Yes. It can be done, and it’s RELATIVELY straightforward as far as reprocessing goes, but it’s rarely worth the effort and expense involved; in many cases it’s both easier and less expensive to just pop in a new tube. For the most part, tubes on CO2 lasers are regarded as a consumable.

Marshall

2023-02-23

290

1

0

Ich habe einen Vevor 80W co2 Laser.Spiegel reinigen mit Isopropanol nehme ich an. Wie vorsichtig muß man an die Spiegel gehen? Verstellen Sie sich leicht, bin ehrlich, habe echt bammel davor die Dinger mal einstellen zu müssen....Wie oder mit was schmiert ihr eure Laufschienen?Wie oft sollte man reinigen und schmieren? Ich schneide se...

Keegan

2023-02-18

441

1

0

Recently, scientists have found that by simply adjusting ionic liquids (penetrating liquids), lasers can produce a series of wavelength changes, thus producing a "color change" effect that is simple, efficient and highly customizable.Researchers at the Brookhaven National Laboratory of the United States Department of Energy (DOE) emit green...

roy

2023-01-31

276

1

0

Laser cutting machines are generally divided into metal laser cutting machines and non-metal laser cutting machines. Non metal laser cutting machines mostly use CO2 lasers as generators, while metal laser cutting machines use fiber lasers as generators. Both types of cutting machines play an important role in industrial production, greatly improvin...

Williams

2022-11-18

359

0

0