RDC6442, the software version before V8.0.06, draws a diagram and downloads it to the motherboard, but "file incompatibility" will appear when the panel is processed. It is OK to download it again, I don't know why?

Andrej

2022-11-14

262

8

4

Hallo everyone!I hope you can help me, I’m slowly running out of ideas.I’ve upgraded my old 130w CO2 laser from a Puhan Ph3 controller to a new Ruida RDC6445Scontroller (complete set).Laser power supply, motor drivers, etc., remained the same.The conversion itself was not difficult.Now, everything seems to work fine.Home posit...

Pr0phezz

2024-01-27

76

1

0

I have an Ruida RDC6563FG laser controller controlling a Max laser.If I manually open the Max laser shutter off the Ruida control panel the shutter opens and the laser fires correctly.But when I create a program using RDCUTIST, the program runs through its sequence, but the laser shutter does not open.Any help would be appre...

Cityslicker

2023-07-19

271

7

0

There is support for ruida?I am using rdcutist 3.02.20 beta.I have the following problems:- Frame speed is very slow, can't change it.- If I connect parts and load them into RG6563FG. Cutting occurs with a visit (not always)- Focus, axis A can only be controlled in external coordinates. - IMPORTANT: In layer, membrane mode - does not turn on t...

Pavel_TT

2023-08-30

345

23

4

HiI have read the manual of RDC6563F and RDC6563FG-LITE (in Chinese). I understand the difference between these models. I don't know how to connect the BM111 cutting head with AutoFocus. Can you help me? Which axis of the RDC6563 controller controls the AutoFocus function of this head and how to change it in the RDCutist 3.02.20 software. Can the ...

Robertulus

2023-09-18

78

3

1

I am looking for help with my Ruida 6445G Controller. The problem is the Z Axis. I have tried multiple options. Trying to get the Z Axis to show me in mm the actual length is not happening. For 100mm on the Controller is only about 4mm movement. I tried using the Auto calculations of Entering this information and the stepper was set at 0.2 which th...

DJPeterLewis

2023-01-30

176

11

2

Can sombody help me whit software Vcutwork ?After changing the mainboard i can't put the right parameters back before.I don't have backup .?The milling cutter and the knievs don't take the rise that i set from keyboard and they allways get up in the hom position to make the jump and i loos too much time in this mode .I need to know how can...

sWF9knbM

2023-02-08

180

2

1