Hello everyone, the issue from last time has been resolved. However, I encountered a new problem today. My RDC6332NM control system is experiencing an abnormal voltage at the laser control signal port...

• power supply
• RDC6332NM
• control system
• laser cutting
• RuiDa

My laser engravers use the RDC6332NM controller, but today I encountered a strange issue during operation: the machine only moves in one direction. Could someone please help me? Thank you.

• motion system
• RDC6332NM
• laser engraving
• control system
• RuiDa

I switched to manual mode and pressed the Z+and Z - buttons on the control panel, but the Z-axis motor did not move. The model is RDC6332NM， How to solve it?

• motion system
• coordinate axis
• RDC6332NM
• laser cutting
• RuiDa

My laser equipment has been working continuously for more than ten hours, using RDC6332NM. Now there is a problem where the cutting head has severe overshoot or shaking when following the state. How c...

• RDC6332NM
• laser head
• laser cutting
• RuiDa

My machine is equipped with RDC6332NM, and the cutting head automatically focuses or moves downwards at any time. How can I solve this problem?

• motion system
• RDC6332NM
• laser head
• laser cutting
• RuiDa