English

French research team successfully develops new orange laser

668
2025-03-04 15:16:08
See translation

A research team in France has reported a novel laser that emits light in the orange region of the spectrum, indicating its potential applications in flow cytometry and astronomical laser guidance.

In the research results just published in Optics Express, the team (including researchers from the É cole Polytechnique in Caen, France and Oxxius, a laser manufacturer based in Lannion) claimed that the samarium doped light source can output 23.9mW of power in continuous wave operation at a wavelength of 605nm.

We report the first visible light orange samarium laser directly pumped by a blue 465nm gallium nitride semiconductor laser diode. Our work represents the principle verification of compact low threshold semiconductor pumped orange and red samarium lasers


Figure 1: Layout of Sm: LiYF4 laser. The figure shows pump configurations 1 to 3, λ/2-AR coated half wave plate, FL focusing lens, CL collimating lens, N.A. numerical aperture. Source: Jonathan Demaimay, Pavel Loiko, Esrom Kifle et al., "Dior pumped orange Sm: LiYF4 lasers emitting at 605 nm", 《Optics Express》(2025).

 



Figure 2: Spatial characteristics of pump radiation from different blue light sources used for pumping Sm: LiYF4 laser: Figure 2: Spatial mode profile measured at the beam waist (at full power); The following figure shows the evaluation of the corresponding beam quality parameter M2. Source: Jonathan Demaimay, Pavel Loiko, Esrom Kifle et al., "Dior pumped orange Sm: LiYF4 lasers emitting at 605 nm", 《Optics Express》(2025).

Enter Orange
The paper states that laser emission with an orange wavelength (defined as 590-625nm) is of great significance in flow cytometry, as it can use fluorescent probes with a wider range and higher efficiency.

Other important applications include astronomy, where laser guided stars with a wavelength of 589nm are now routinely used in conjunction with adaptive optics systems to correct atmospheric distortions. Due to the absorption band at 603nm, ozone gas detection is also possible.

However, obtaining orange wavelengths using solid-state materials is difficult, especially when combined with strong continuous wave emission, high beam quality, and linear polarization.

Braun and colleagues reported that several methods are currently being studied to address this challenge, such as using complex crystal combinations in Raman laser design or using semiconductor disc lasers with frequency doubling. Another method is to use crystals doped with certain rare earth ions (especially praseodymium or samarium), which can directly emit orange spectra without frequency conversion.

The research team pointed out in the paper that "recent progress in developing blue gallium nitride laser diodes has promoted their use as pump sources and opened up new paradigms for compact, continuous wave, and efficient laser sources that do not require nonlinear optical components.

Figure 3: The red and orange spectral ranges of Sm: LiYF4 laser. Source: Jonathan Demaimay, Pavel Loiko, Esrom Kifle et al., "Dior pumped orange Sm: LiYF4 lasers emitting at 605 nm", 《Optics Express》(2025).

Figure 4: GaN semiconductor pumped Sm: LiYF4 laser: (a) input-output correlation and (b) typical laser emission spectra obtained from fiber coupled diodes and free space diodes under different output coupling rates TOC conditions, with η - slope efficiency and Pth - laser threshold. Source: Jonathan Demaimay, Pavel Loiko, Esrom Kifle et al., "Dior pumped orange Sm: LiYF4 lasers emitting at 605 nm", 《Optics Express》(2025).

Crystal selection
Although samarium doped lasers are not a new concept and red emission sources were developed as early as 1979, the latest work uses lithium yttrium fluoride (LiYF4) crystals, which have better thermal performance, higher optical quality, and lower production costs compared to alternative designs reported so far.

Figure 5: Photos of 1.1 at.% Sm: LiYF4 ingots grown under (a) natural light and (b) ultraviolet lamp irradiation. Source: Jonathan Demaimay, Pavel Loiko, Esrom Kifle et al., "Dior pumped orange Sm: LiYF4 lasers emitting at 605 nm", 《Optics Express》(2025).

The research team stated, "In this study, we reported the polarization spectra and first laser operation of Sm3+doped LiYF4 crystals in the orange (605nm wavelength) and red (648nm wavelength) bands, as well as the first semiconductor pumped visible samarium laser


Figure 6: Spectral diagram of Sm3+ions in LiYF4 crystal. Source: Jonathan Demaimay, Pavel Loiko, Esrom Kifle et al., "Dior pumped orange Sm: LiYF4 lasers emitting at 605 nm", 《Optics Express》(2025).

The research team believes that by carefully selecting the concentration of samarium ion doping, the efficiency of the laser can be further improved, while longer crystals can increase output power.

They concluded, "Considering the positive thermal lens in the a-cut LiYF4 crystal, we envisioned a compact (microchip type) semiconductor pumped Sm: LiYF4 laser that reduces cavity losses by bonding cavity components.

Source: Yangtze River Delta Laser Alliance

Related Recommendations
  • HENGTONG listed on the Fortune Global 500 list of brands

    Recently, the 2024 (21st) World Brand 500 ranking list exclusively compiled by World Brand Lab was released in New York, USA. HENGTONG brand participated in the selection for the first time, standing out from more than 8000 participating brands in 32 countries worldwide and ranking 395th on the "Top 500 World Brands" list. This year, there are a total of 21 new brands on the global list, of whic...

    2024-12-17
    See translation
  • HGTECH Laser's New Product Debuts at the 2025 Munich Shanghai Light Expo

    New Product for Wafer Testing Probe Card Manufacturing Equipment Project This project adopts vision guided laser precision cutting to separate the probe from the crystal disk, and then generate a product mapping image for use in the next process. When picking up the probe, multi-point reference surface fitting technology is used to achieve non-contact probe suction and avoid force deformation. A...

    03-07
    See translation
  • GE Additive has been renamed Colibrium Additive, continuing to lead the additive manufacturing industry

    In April 2024, GE Additive was renamed Colibrium Additive. Colibrium Additive (formerly GE Additive) is a subsidiary of GE Aerospace Propulsion and Additive Technology (PAT) and was established at the end of 2016. Nowadays, it is a trusted partner and manufacturer of industrial metal 3D printers and metal powders, as well as a service provider for industrial metal 3D printers and metal powders. It...

    2024-04-30
    See translation
  • The efficiency of crystalline silicon solar cells has exceeded 27% for the first time, and Longi's research results have been published in Nature

    Recently, Longi Green Energy Technology Co., Ltd. (hereinafter referred to as "Longi"), as the first unit, published a research paper titled "Silicon heterojunction back contact solar cells by laser patterning" online in the journal Nature, reporting for the first time the research results of breaking through 27% of the photoelectric conversion efficiency of crystalline silicon cells through full ...

    2024-10-18
    See translation
  • The Future of Data Center Communication: Quantum Dot Semiconductor Comb Laser

    In the constantly evolving field of technology and data communication, researchers have made significant breakthroughs: developing a continuous wave O-band quantum dot semiconductor comb laser for wavelength division multiplexing optical interconnection. With its impressive performance characteristics, this development is expected to completely change the way we manage and transmit data, especiall...

    2024-02-21
    See translation