Try another carving on white medium density fiberboard

2024-11-05

On white bath panel mdf but as image this time.
sculpfun s9 2000 mm at 75% using jarvis setting and air assist with good ventilation.
Edited in gimp and inkscape to remove speckle and firm up lines.

laser carving

Comments (2)

Henry
Report
Want to be extra careful of the bath panels. They are actually masonite with melamine as a white surface. Good ventilation is necessary as you know already. BTW: Using a CO2 laser these panels are a real mess when cutting.
2024-11-06
0
Reply
- Ethan
  Author
  Report
  Stuff I use is only 3mm thick and sold as white faced hardboard/MDF not Masonite. It has a Matt plastic like finish.
  2024-11-07
  0
  Reply