Hello friends, I have a problem with my Laser Atomstack S20Pro 20w - Blue laser. The laser does not engrave at power up to 0-20% and also does not engrave at speeds above 3000mm/m.-20000mm/m. For a better understanding, I created an engraving test. Birch plywood MDF 4mm is used. ...

• laser engraving
• laser carving

Ethan

03-26

955

4

0

I’m only just getting started with LB, and I doubt this is actually a LB issue, but the number of passes does not seem to work like I would have expected. I have some experience with lasers and optics going back years. My expectation was that if I can get a 1mm deep cut on pass...

• laser

Ethan

03-04

928

3

0

Everything works great except lightburn is not tracking, in the program, my laser’s movement. The laser is burning, it works fine. But as you can see on the attached image, the upper green and red squares? Those never move. Any advice is appreciated, I searched but didn’t find an...

• laser

Ethan

02-18

1.1K

4

0

On white bath panel mdf but as image this time. sculpfun s9 2000 mm at 75% using jarvis setting and air assist with good ventilation. Edited in gimp and inkscape to remove speckle and firm up lines.

• laser carving

Ethan

2024-11-07

1.1K

2

0

In my ongoing quest to get my laser up and running, i have found the manufacturer has discontinued my machine and no replacement parts are to be had. It a Kentoktool JL5 5.5w. I have access to a Laser Tree 10w laser module with its own 12v power supply and an adapter board. The c...

• laser

Ethan

2024-10-25

862

2

0

Hi I have recently been trying to create and print a curved 90 degree markings scale Tried quite a few methods, but most relate to circular array. I create a 90 degree scale with 1 deg graduations and then by working right to left (green box) I try to shorten and align groups of ...

• laser

Ethan

2024-09-30

1.1K

1

0

The brushless motor controller (also known as the driver) is a key component that controls the normal operation of the brushless motor. If the controller is broken, the brushless motor cannot function properly. The following are the repair steps for a faulty brushless motor contr...

• motor
• brushless motor

Ethan

2024-08-12

1.1K

0

0

1. Speed control Variable frequency motors can achieve speed control of the motor by changing the power frequency, meeting different speed and load requirements in the production process. This speed regulation method can accurately control the motor speed, improve production effi...

• motor
• frequency motor

Ethan

2024-07-20

842

1

0

Servo motors usually have a braking function, which generally refers to the electromagnetic mechanical holding brake device at the rear end of the servo motor. It is usually installed at the rear end of the motor and brakes the motor and locks the motor spindle through the brake ...

• motor
• servo motor

Ethan

2024-04-16

1.1K

1

0

Let me share my personal opinion, Industrial vision definitely requires, 1. Hardware stability is beyond doubt. 7 * 24 operation should be used in many scenarios, as well as on-site working environments (temperature, dust, etc.) 2. Piracy and genuine software. (Small businesse...

• control

Ethan

2024-01-04

833

3

0