Can I install both proximity sensors and mechanical limit switches on each axis of a Ruida RDC 6445S controller? I'd like the proximity sensors to act as the primary reference, with mechanical switche...

• RDC6445S
• laser head
• control system
• RuiDa

When I was using LaserGRBL for laser engraving, I found that the direction of the laser head movement was completely uncontrollable. Although clicking on the X-axis to move forward in the software, th...

• coordinate axis
• LaserGRBL
• laser head
• laser engraving

I have an RDC6445S controller on a dual-head laser machine with independent offset capability. The distance between the two laser heads is 170mm, and the cutting area is 1600×1000mm. In the manufactur...

• coordinate axis
• RDC6445S
• laser head
• control system
• RuiDa

The laser head functions normally during startup and reset, returning to the correct position each time. However, after completing an engraving or cutting job, the head moves to the top-left corner as...

• laser head

I encountered a problem while operating the RDD6616U control system during the machining process. When the dual head mutual movement mode is enabled, the auxiliary head can move independently and work...

• RDD6616U
• laser head
• RuiDa

My fiber laser equipment uses the RDV6563FG control system. Today, I was operating normally for processing, but I found that the cutting head had a large following error. During the operation of the e...

• RDV6563FG-NET
• laser head
• fiber laser
• control system
• RuiDa

Today, I used CO2 laser cutting equipment to process workpieces. The control system is RDC8445S. After starting, the cutting head ran normally, but there were obvious uncut areas on the edges of the c...

• galvo scanner
• beam delivery system
• RDC8445S
• laser head
• RuiDa

When I was operating the RDWelder-SW handheld welding system, the device was unable to connect properly. After turning on, communication cannot be established between the control panel and the welding...

• beam delivery system
• RDWelder-SW
• laser head
• laser welding
• RuiDa

My laser equipment is paired with an RDV6563FG control card. During today's maintenance inspection, it was found that the equipment was running unstable, occasionally experiencing slow restarts, commu...

• RDV6563FG-NET
• laser head
• control system
• RuiDa

Can anyone help me? My device is paired with the RDC6563FG control system, and I am preparing to perform capacitor calibration. Following the procedure, I slowly adjusted the probe position to bring i...

• RDC6563FG
• laser head
• fiber laser
• control system
• RuiDa

The RDC6332M control system, when I turn on the automatic focus or follow function, the cutting head will continue to move downwards without any tendency to stop or rebound. Even if the height of the ...

• motion system
• laser head
• control system
• RDC6332M
• RuiDa

The control system used for my CO2 laser equipment is RDC6445G, which can return to the set positioning point after processing is completed. However, when the point exited, the laser head did not retu...

• RDC6445G
• laser head
• control system
• CO₂ laser
• RuiDa

Hello everyone! I have a question to ask. After using RDWorksV8 to complete laser cutting processing, I found that the laser head did not stay at the predetermined positioning point, but stopped at an...

• RDWorksV8
• laser head
• RuiDa