The cutting drawing is not closed, and there is no problem with the drawing. How to solve this problem?
2023-01-0938620I am looking for help with my Ruida 6445G Controller. The problem is the Z Axis. I have tried multiple options. Trying to get the Z Axis to show me in mm the actual length is not happening. For 100mm on the Controller is only about 4mm movement. I tried using the Auto calculations of Entering this information and the stepper was set at 0.2 which th...
2023-01-30393112When RDC6563F is used, XY axis does not move manually.
2023-01-0353030I power laser on and it only displays connecting to controller. I have disconnected the him from the controller and nothing homes. I have led 15 and 12 lit up with eithernet discounted. Homing switches work chiller input works and all drives are good no faults. Any ideas?
2023-02-0241620Can sombody help me whit software Vcutwork ?After changing the mainboard i can't put the right parameters back before.I don't have backup .?The milling cutter and the knievs don't take the rise that i set from keyboard and they allways get up in the hom position to make the jump and i loos too much time in this mode .I need to know how can...
2023-02-0836021Once powered on, the cutting head will always move upward, and will not stop. Switch to the manual state, and the motor can be controlled to move, and then switch to the automatic mode, and always move upward.
2023-01-1043510The cutting head does not lift up and down, but the motor has sound.
2023-01-1027010After normal connection, press the auto-focus button, and the cutting head will move upward all the time.
2023-01-1032410After cutting, it is found that the graphics in the software and the actual graphics are reversed from left to right or up to down.
2023-01-09384106563F moves manually on the panel according to Z-axis, and the cutting head does not move.
2023-01-0546220The processing serial number arrangement is invalid.
2023-01-0532010Just installed ruida 6442 and control is always reseting 10000mm x 10000mm y and I can't figure it out for the life of me
2022-12-2843010It is always impossible to cut through. Finally, it has to be cut twice, and the effect is not good. How to adjust it?
2023-01-0940510It is useless to set a fixed point, no matter how many times you set a fixed point, or start cutting from the same position.
2023-01-0633810The border running is normal, but the click to start does not respond.
2023-01-0633110
- Sem Dados
Português
- English
- 简体中文
- 繁体中文
- Français
- Русский
- Italiano
- 日本語
- 한국어
- Português
- Deutsch
- Español
- Türkçe
- Ελληνικά
- Nederlands
- Tiếng Việt
- Polski
