chanelink logo
CHANELINK
Português

Ruida Problem Verbindung Alpha5 smart Plus

Categorias:
Ruida
334
2
Ver tradução
2024-04-18

Halle habe die Steuerung RDC6563FG und auf der Z-Achse Servo Alpha5 smart Plus.

Bekomme diesen aber nicht zum Laufenden. Kann mir jemand helfen und die richtige Verbindung

und Anschlussbelegung zwischen RDC6563FG und Servo5 smart Plus geben. Ich denke das Belegung

nach Seite 36 Ruida nicht richtig ist. 

Bitte um Hilfe komme nicht weiter hier ein paar Fotos

Grüße Matthias

 
C

    • aO5ZCpeb

      2024-04-18
      Sorry, can't speak English, I did this with a translator!
Halle has the RDC6563FG control and the Alpha5 smart Plus servo on the Z axis.
But I can't get this up to date. Can someone help me and find the correct connection
and pin assignment between RDC6563FG and Servo5 smart Plus. I think the occupancy
according to page 36 Ruida is not correct.
Please help can't get any further here are a few photos

Greetings Matthias
        Ver tradução
        Responder
        • Snow Sun

          : did you connect the motor to the Z axis for a live focus control? if it is, please confirm the followings: 1 the Z axis motor should work at the SPEED mode that include of the encoder feed back, analog for the speed control and the zero speed control port. 2 you should set the general input or output to be the dedicated one in order to work with the live focus action. 3 your diagram is not clear. if possible,please send me the datasheet of the servo( better in English), i will check and help you in detail

      Recomendações relevantes
      Coletar
      Relatório