chanelink logo
CHANELINK
English

Not Marking

Categories:
Laser
Tags:
365
1
See translation
2023-02-24

I have MP-30 LiteMarker 30W Split Laser Engraver… I have EZCAD 2 and have installed the driver just fine. I have adjusted the focus. I have used the EZCAD 2 that was shipped with the laser.
C

    • Payson

      2023-02-27
      1. Check if all buttons are turned on
2. Check whether the driver is connected correctly
3. Check parameter settings, output or fill
4. Turn the rotary wheel up and down to check whether there is laser emission
        See translation
        Reply
      Relevant recommendations
      Collect
      Report