During power on and reset, the X axis stopped after touching the limit switch, while the Y axis was still running slowly at the origin.

jessie

Categories:

Ruida

Tags:

347

See translation

2022-12-30

During power on and reset, the X axis stopped after touching the limit switch, while the Y axis was still running slowly at the origin.

Marshall

2023-01-03

① The polarity of the Y axis is reversed. Reset the polarity;
② The limit switch is broken and needs to be repaired.

See translation

Relevant recommendations

Collect

Report

Once powered on, the cutting head will always move upward, and will not stop. Switch to the manual state, and the motor can be controlled to move, and then switch to the automatic mode, and always mov