chanelink logo
CHANELINK
English

Not completed after returning to position

Categories:
Laser
618
1
See translation
03-20
longer b1 question. sometimes, after a job… the laser goes to the position which i requested it goto… and the lb status line shows 99% complete, and looks like it is working on something. I have had to click on the stop button before to get the software to complete whatever task it was working on and allow me to do my next task. is this normal?
C

    • Henry

      03-21
      This is normal for weak USB connections. Try to change the cable and remove electrical disturbances and check again.
        See translation
        Reply
      Relevant recommendations
      Collect
      Report