The control system I am using with my device is RDC6685U, and I encountered an issue while operating the HMI interface. When attempting to open or upload a file, the system pops up a prompt saying 'Fi...

• RDC6685U
• control system
• RuiDa

When I was debugging the device, the RDC6685U controller frequently prompted the "distance limit" alarm. Whenever the machining axis moves to a specific position, the system automatically limits and i...

• camera
• RDC6685U
• control system
• RuiDa

I started the processing, but the double beam equipment suddenly malfunctioned during processing, with one fast and one slow, causing an instant deviation and collision with the machine. I immediately...

• RDC6685U
• control system
• laser cutting
• RuiDa

How can I increase the length of U- Feed belt or not to count the meters as I can only get about 4 full rotations of the U-feed belt when cutting long rolls of material. I then have to press reset eve...

• RDC6685U

My CO2 laser cutting machine is equipped with an RDC6685U control system. I am now planning to encrypt the motherboard. How should I proceed? Thank you!

• RDC6685U
• control system
• CO₂ laser
• RuiDa

When I tried to connect RDWorksV8 to the RDC6685U controller, the system was unable to establish communication. I checked the USB and Ethernet connections and confirmed that the interface was not loos...

• USB
• RDWorksV8
• RDC6685U
• control system
• RuiDa

My CO2 laser equipment is paired with the RDC6685U control system, and I encountered a strange problem: when I pressed the reset button on the panel, the system did not return to normal as expected. I...

• RDC6685U
• control system
• laser cutting
• RuiDa

The control system model I use for my CO2 laser cutting machine is RDC6685U. After starting the processing, the panel suddenly displays a "water protection alarm". I checked the water tank, the chille...

• RDC6685U
• control system
• cooling system
• CO₂ laser
• RuiDa

Hello everyone! My CO2 visual cutting machine uses the RDC6685U control system, and in order to achieve accurate images, I specially performed cross correction. The parameters on the screen look norma...

• camera
• CO₂ visual cutting
• RDC6685U
• control system
• RuiDa

My CO2 cutting machine is equipped with the RDC6685U control system. Today, I tried to connect it to my computer via USB, but it still couldn't communicate properly. I don't know if it's a problem wit...

• USB
• RDC6685U
• control system
• CO₂ laser
• RuiDa

Does anybody know the latest and stable software upgrade for RDVisionWorks(1.00.115)? I am having big issues with Ver1.00.115 running (Dual beam). After camera calibration, i could not go any further ...

• RDVisionWorks
• RDC6685U
• laser cutting

When doing camera calibration, i can't seem to get the X/Y compensation correct. I am using RDVisionWorksV1.0 If anybody can help please.

• RDVisionWorks
• RDC6685U

I am using RDUnion software to configure the sustem, but can't get U-drive to work in Dual beam. I would apreciate if anybody can help.

• RDC6685U
• RuiDa