When using laser engraving software LaserGRBL, if the estimated time is inaccurate, please carefully read the following explanation: Each segment has its own programmed execution speed and its own le...

• LaserGRBL
• laser engraving

Gary

06-15

106

0

0

LaserGRBL detect GRBL configuration and remove (hide) some options if not compatible with your firmware/configuration. 1. M4 Dynamic Laser Power Mode is available only if your controller is updated w...

• LaserGRBL
• laser engraving

Adrian

04-10

233

0

0

Each segment has its own programmed execution speed and its own length (length of the segment, or lenght of the arc). The tracing movements G1, G2, G3, are performed at the speed F set in the GCode, ...

• LaserGRBL

Michael

04-08

205

0

0

If you find that the laser engraving machine moves too fast during laser engraving, causing inaccurate positioning or affecting engraving quality, you can solve this problem by adjusting the following...

• coordinate axis
• LaserGRBL
• laser engraving

Thomas

02-04

236

0

0

Set a speed in LaserGRBL, but engraving occurs at slower speeds. During processing LaserGRBL always command the speed you requested. However, there are reasons why the engraver may move slower. The f...

• motion system
• LaserGRBL
• laser engraving

Patrick

2025-12-19

337

0

0

LaserGRBL work only with boards that implement Grbl. If you are sure that your board is Grbl compatible and you experience connection problem please verify that you are using the proper COM port and c...

• LaserGRBL
• laser engraving

Gilbert

2025-12-19

346

1

0

I have a Genmitsu 3030 CNC machine with a 5.5W laser installed on it. Overall, it works normally. My question is how to check if the focus is normal? LaserGRBL has a focus setting button. After pressi...

• LaserGRBL

Simon

2025-11-10

690

3

0

Can LaserGRBL be compatible with CNC/milling machines? What should I pay attention to? Do I need to understand CAD?

• LaserGRBL

Smith

2025-10-29

754

2

1

I have an Atomstack A5 Pro equipped with a 5W laser. The problem I encountered is that when carving or cutting, the laser stops for a few milliseconds and the carving leaves burnt spots at the stop. C...

• LaserGRBL
• laser engraving
• laser cutting

LWE

2025-03-31

1.2K

4

0

Hello friends, I have a problem with my Laser Atomstack S20Pro 20w - Blue laser. The laser does not engrave at power up to 0-20% and also does not engrave at speeds above 3000mm/m.-20000mm/m. For a be...

• LaserGRBL
• LightBurn
• laser engraving

Ethan

2025-03-26

1.3K

4

1

I’m trying to see my GRBL settings, but I can’t type anything into the command window. Side note: I’m new to this, and I’m only trying to see these settings to address a different issue. I have a Monp...

• LaserGRBL
• fiber laser

Tim Johnson

2025-01-22

1.4K

2

0

hello i havent used my 3018 in a while and am wondering what im doing wrong. i’m all set up wit grbl and lightburn 1.7.03 I power up and it begins to home motors just stuttuer terribly and wont move.h...

• motion system
• LaserGRBL
• LightBurn

Jack Wilborn

2024-10-31

1.3K

1

0