I'm looking for step-by-step guidance on setting up a rotary attachment in RDWorks. The rotary is spinning, and I've tried changing the steps and diameter values, but the outcome remains unchanged. Am...

• rotate
• RDWorksV8
• RuiDa

I found that the punch cannot rotate while operating the RDD6584G control system. The system is powered on normally and there are no alarms on the display interface, but the punch does not respond aft...

• rotate
• RDD6584G
• control system
• RuiDa

I initially used LaserGRBL, but I am not familiar with many operations. After opening the software, I searched for the rotation function on the interface, but the operation steps were not very intuiti...

• rotate
• LaserGRBL
• laser engraving

I have a CO2 laser cutting machine and I found that the U-axis cannot use the multi-point positioning function properly when working as a rotating axis. Whenever I try to set multiple positioning poin...

• rotate
• coordinate axis
• CO₂ laser
• RuiDa

Hello everyone! How do I calculate the circumferential pulse parameter value for rotary engraving using RDWorksV8? Thanks in advance!

• rotate
• RDWorksV8
• laser engraving
• RuiDa

When using RDWorksV8 for rotary engraving, I chose "rotation specific step distance" as the calculation method. How do I calculate it? Please provide a detailed explanation, thank you!

• rotate
• RDWorksV8
• laser engraving
• RuiDa

My vibrating knife cutting system is RDD6584G. I have a simple question, how do I calculate the pulse?

• rotate
• RDD6584G
• RuiDa

My cutting machine uses a ruida controller, RDC8445S， I set the U-axis as the rotation axis for cylindrical machining, but I found an issue: once the rotation axis mode is enabled, the normal multi-po...

• rotate
• coordinate axis
• RDC8445S
• control system
• RuiDa

I am using the brush function in RDWorksV8 for rotary machining, intending to have the Z axis replace the U axis to complete continuous machining of the rotary surface. After downloading the file and ...

• rotate
• coordinate axis
• RDWorksV8
• RuiDa

My vibration knife controller is RDD6616U. Today, when I was operating the machine for processing, the equipment could move normally, and the vibration knife could move up and down, but the punch head...

• rotate
• RDD6616U
• control system
• RuiDa

My controller is RDC6442G. I set the U-axis as the rotation axis and found that the multi-point positioning function cannot be enabled. No matter how I adjust the software parameters, the system still...

• rotate
• coordinate axis
• RDC6442G
• control system
• RuiDa

I am using the RDD6584G vibration knife control system. After setting the rotation axis pulse, I found that the rotation angle is abnormal. I don't know how to handle it? Please seek guidance from pro...

• rotate
• RDD6584G
• RuiDa