Hello, I'm upgrading an oscillating knife cutting machine. The machine had a Galileo controller. The PC used to operate it lost its hard drive. I couldn't configure the software from the backup I had.I purchased a Ruida RDD6616u controller from Wavetopsign on Aliexpress. I asked them for the installation manual and software on several occasions. I ...

Geozapata

2 dni temu

25

0

0

I use a new Monport 80w camera with RDC6442G.However, I hit autofocus in Lightburn or the Z-axis menu and the camera breaks. (This camera does not have a Z-axis limit switch).Can I disable the autofocus feature in the control panel or machine settings?I looked at the Ruida manual but it didn't help much with this problem.

ElenaXavier

05-15

336

1

1

HelloDoes anyone knows, will LightBurn works with Ruida RDC8445S ?I try trial version, and Ruida always in disconnected state, Serial USB/Ethernet IP both not works.PS: RDWorks detect controller by USB and IP (WiFi) - both success 

96DED7E9

05-15

260

1

0

This is a magic of ruida controller

S A Designs

2024-11-02

393

2

2

Product DescriptionAP8854 is a wide voltage range step-down DC-DC power management chip that integrates enabling switch control, reference power supply, error amplifier, overheat protection, current limiting protection, short circuit protection, and other functions, making it very suitable for wide voltage input step-down use.AP8854 with enable con...

Leon

2024-08-17

402

2

1

Hi,I have a RDC6563FG-LITE and the Manual is only in chinese and has not been translated to EN, I have used a translating service to translate the PDF but the translation is lacking and I have some questions about the controller.2.4 - RS232 The RS232 serial port is mainly used to control fiber lasers. The interface definition is as shown in the fol...

Juan Barkhuizen

2024-04-29

501

4

0

Hello!I can't adjust the gas pressure regulator.in the setting, the slok costs 1MPa. ITV2030 shows 0.75MPa.Can you tell me how to do the same?

Pavel_TT

2023-07-10

680

5

0