The stepper motor has resonance issues

04-02

I am having some problems with the noise and grinding from the x-axis. Soundls like mad cow disease! I am using an 17HS24-2104S STEPPER with a DM542T driver. Can not find a smooth setting. Per sepperonline I have added a resonance mount with rubber cushion and it is a considerable amount quieter but still bad.

Comments (4)

Cyril
Report
Just a long shot… but check the driver setting (if any) make sure they are set to the the recommended by the manufacturer.. this is my system , it has the dip sw setting that are recommended on the stepper motor… Long shot but, if it gets changed… could be an issue…
04-09
0
Reply
- Noah
  Author
  Report
  I just swapped wiring on x an y and no change. So I looked at some spar stepper motors and the were smoother turning by hand. So I replaced the motor and the x-axis is near perfectly quiet! Wonderful. I have been working on this motor forever.
  04-10
  0
  Reply
Aaron
Report
I usually change my speed a little.
04-07
0
Reply
- Noah
  Author
  Report
  I have tried several speeds. Weird but the y axis is great.
  04-08
  0
  Reply