Zero degree carving, but there is an angle when it comes out

2024-10-09

We are setting up a laser machine to carve copper; From the first test, for example, by digging a small square at 0 degrees, a Z-dip angle of approximately 10-15 degrees can be obtained. What parameters should we use for perfect straight line cutting?

Comment (1)

Payson
Report
It's simple, you have to do chip removal like drilling a hole, enter one or two millimeters, and then completely come out to crush chips or remove dust. If you are drilling a hole to press resin, use a laser to do the same thing to close it and blow away the waste until the end of the hole. The difficult part is getting everything done right
2024-10-10
0
Reply