chanelink logo
CHANELINK
Français

Home position and laser position not the same

Catégories:
Laser
Tags:
634
1
Voir la traduction
2023-10-18

I recently updated my sculpfun s9 with limit switches, following the youtube video provided, i learned that where the laser hits the limit switches and where Lightburn sees the laser, is not the same. Lightburn sees it at being X: -377.00 Y: -392.00 Z: 0.00. Would there be a way to make its current position the new 0,0 ?

LightBurn
C

    • Marshall

      2023-10-19
      "X: -377.00 Y: -392.00 Z: 0.00"

Is this the reported position after homing? If so, try running these commands in Console:

G10 L2 P1 X-377Y-392
$10=0
$H
?

What is the reported position after running those commands?
        Voir la traduction
        Répondre
      Recommandations pertinentes
      Collecter
      Rapport