chanelink logo
CHANELINK
Ελληνικά

The starting and ending positions are different

Κατηγορίες:
Λέιζερ
Ετικέτες:
799
3
Δείτε τη μετάφραση
2024-10-11
So when I engrave or cut the laser moves to the same position it starts from. When I use the rotary and engrave tumblers the laser head goes to a differant position from where it starts. This has changed since I upgraded from 1.6 to 1.7.01. How do I change so laser head parks after engraving in the same position it starts?
C

    • Cyril

      2024-10-12
      Check if you have this option selected.
      Δείτε τη μετάφραση
      Απάντηση
      • Noah

        : not sure if return to finish should be checked or not… I have always used " Currant position"

      • Cyril
        Απάντηση
        @Noah

        : You need to select “Return to Finish Position” if you intend to park the laser head in a certain location. That location is set below on “X” and “Y”

    Σχετικές συστάσεις
    Συλλογή
    Αναφορά