In Optimization Settings, disable “Remove overlapping lines” or make the value much smaller. Your current setting is conflating the lines as overlap at the scale you’re trying to burn.
0
Reply
Image Trace Cut is hindered when scaling down an image
I have traced a descent sized image in terms of L x W, so that the Trace Image feature can grab as much detail as it can.
When scaling down the traced image, part of the trace disappears and there is a disconnect which can only be seen in the preview tab.
Image preview when making the trace bigger and there is no disconnect:
How can I make sure the scaling down is not butchering the image trace?
Somehow, this was not happening yesterday. I even have test pieces which were cut out just fine…
