When RDC6563F is used, XY axis does not move manually

Analysis and troubleshooting:
① The wiring of the servo driver is incorrect.
② The servo driver parameters are not set correctly.
③ The limit polarity is set incorrectly, causing the movement to stop.
④ The servo driver generates an alarm.

• Christian

  : Solution: ① Refer to the relevant wiring instructions in the user manual for correct wiring. ② Set the parameters correctly according to the instructions of the servo driver. ③ Set the limit polarity correctly. ④ Please power on the servo again to eliminate the alarm.

hi , i use this controller too. are wiring was connect corectly?