chanelink logo
CHANELINK
English

origin

Categories:
Ruida
148
1
See translation
04-28
 
Good evening I made a CNC plasma with a 6442 G rough controller. The machine works perfectly but when I ask it to run the home button it goes in the opposite direction to where I want it to. Even if i change origin of the drawing sheet, the machine continue to reset the axis (both x and y) in the opposite direction (with inversion command) .  i tried to change the "reverse" function but in this case the arrow on the ruida works opposite to manually move the machine. And the limit switch doesn t work. So i changed the polarity without direction inversion, and i changed the limit switch polarity. It seems working good but whe i switch on the machine the axis run very slow for a while then stop without error signal and everything die. The machine doesnt work any more. 
any idea ? 
im thinking to invert the cable on the motor....
thany you 
Cristiano
C

    • blue sea

      04-28
      Hello! The problem of the opposite direction of the X/Y axis can be solved in the manufacturer's equipment parameters to adjust the motor direction polarity or limit polarity, about the machine to stop after a period of time, there are many reasons for no related error alarm, please provide relevant videos in order to analyze the fault caused by the machine or other aspects.
        See translation
        Reply
      Relevant recommendations
      Collect
      Report