Try another carving on white medium density fiberboard
Categories:
Laser
69
2
0
2024-11-05
On white bath panel mdf but as image this time.
sculpfun s9 2000 mm at 75% using jarvis setting and air assist with good ventilation.
Edited in gimp and inkscape to remove speckle and firm up lines.
sculpfun s9 2000 mm at 75% using jarvis setting and air assist with good ventilation.
Edited in gimp and inkscape to remove speckle and firm up lines.
C
Henry
2024-11-06Want to be extra careful of the bath panels. They are actually masonite with melamine as a white surface. Good ventilation is necessary as you know already. BTW: Using a CO2 laser these panels are a real mess when cutting.
0Reply-
: Stuff I use is only 3mm thick and sold as white faced hardboard/MDF not Masonite. It has a Matt plastic like finish.
-
Relevant recommendations
- 2023-03-08
-
Not burning by default
1 Reply2023-04-23 - 2023-06-08
-
Array Question for centering
1 Reply2024-01-04
