Abel
Nov 1I received my ray a few weeks ago but have not switched it on yet. I am building an enclosure for it and also a laptop I wanted to use apparently developed a hardrive problem so I have to replace that and trying to figure out which L,T to get. I cannot offer you expert opinion and only have a little knowledge I have read in SM-ray Wiki which is limited to the use with Luban…which I will not be using. Did you run the machine before updating the firmware, and if so did it run ok at that time. Are you saying that the laser returns to Home (x.0/y.0) at bottom left corner…And then you have to move it by hand to the boundry of the object that you want to test the boundary of. So I am thinking, The laser is at the Home position (bottom left) then it should move to the object/work boundry position directed by lightburn…and then Run the boundary, and then Stop and wait for the Work command or return to Home position and wait for Work command. Just to check! Could there be a mixup in lightburn settings, concerning Home/Origin/Current position. Ps, I have heard of old data possibly getting in the way of new data updates. Did you clear old data from memory card before downloading/instaling the new update version.