chanelink logo
CHANELINK
English

Preview doesn't remember reverse selection

Categories:
Laser
603
3
See translation
2024-10-24
I have a project where I have two images, one is inverted, the other not. When I do a Preview I do not want it to be inverted so I deselect it. However, when I go back out, make a few changes and do another Preview, it is back to selecting ‘Invert’. It would be better I think to remember the user’s selection of whether he/she wants to Invert the preview or not.
C

    • Payson

      2024-10-25
      if you preview an image that is inverted, it inverts the preview for you to match. In most cases this is the “correct” behavior.
        See translation
        Reply
        • LWE

          : Thanks, that’s exactly what I thought was happening, is there any way you can get it to ‘remember’ the last Preview you did?

        • Payson
          Reply
          @LWE

          : Not at this time, no. It will remember if there are no images, but if it sees an inverted image it will invert the preview.

      Relevant recommendations
      Collect
      Report