Unable to correctly engrave Laser Master 3
Categories:
Laser
225
1
0
2024-10-21
C
Henry
2024-10-22Looks like speed is set 10,000 to 15,000 mm/m from the engrave test photo Amazing the laser is able to make a mark at that speed. Powe is set from 10% to 50%
0Reply
Relevant recommendations
-
Can’t Weld or Subtract
1 Reply2024-01-04 -
Alarm 3 in Lightburn during filming
2 Replies2024-12-17 - 2022-12-10
-
Cut/Layer, Text without 'Fill'
2 Replies02-14 -
Lines not loading right
1 Reply2023-07-01