The issue with Atezr L2 24V autofocus is only applicable to specific thicknesses
Categories:
Laser
720
1
0
2024-09-28
C
Cyril
2024-09-29you might have to manually adjust the laser head to a different point on the carriage due to travel distances, I have the 48 watt Ihier model with the same z run head
0Reply
Relevant recommendations
-
Cannot connect Comgrow Z1 to LightBurn
0 Replies2023-04-23 -
Laser window not popping up
1 Reply2023-10-14 - 2023-04-01
- 2023-11-22
-
color layer palette not showing
1 Reply2023-08-01