Jamie
Sept 23Your interval is way too high. The D1 specs state a laser spot size of .08 mm. That equals 317.5 LPI. You’re setting of 160 LPI would require a spot size of .16 mm. You’re skipping every other line at 160 LPI.
: I was told that increasing the LPI too much wasn’t good either. It was explained like mowing the lawn. You want to be right next to each other because when you start going over top of the other cut that’s where you get a burn issue. Also I don’t know if you noticed in the first picture I posted, it shows the line appears to skip in the area below the settings information when bi-directional is checked but the line spacing is unformal when it is unchecked. I ran that test based on LightBurns recommendations for the scanning offset adjustment hoping that that could have been my problem.