chanelink logo
CHANELINK
English

I cannot find the machine settings from Lightburn software

Categories:
Lazer
762
1
See translation
2024-09-18
After installing a new X-tool D1 pro 20W, the laser will only frame and return to home. The laser never fires. I discovered the machine settings selection, under edit has disappeared. The Settings and Device setting selections are still there. How do I get back the Machine settings ???. I was already using and X-tool extended laser on this computer and everything was working fine until I installed the second laser.
C

    • Robert Evans

      2024-09-19
      Installing a second laser would have no effect on the Lightburn windows. I just checked Beginner Mode and that would not do it. H O W E V E R, If you select Custom GCode, then it goes away because it is meaningless then.
        See translation
        Reply
      Relevant recommendations
      Collect
      Report