chanelink logo
CHANELINK
English

What to do if the edges are not straight when cutting acrylic?

Categories:
Laser
Tags:
546
1
See translation
2024-01-23

Hi guys,
From the picture you can see that the cut is not straight along the Y axis but the cut along the X axis is straight! Not sure how the fix because if it was the lens focus issue the cut along the X axis wouldn’t be straight as well, right?
I’m using a 2" lens, 90w CO2 laser , the material I’m cutting it’s a 5mm acrylic
Any help would be much appreciated.
Cheers

LightBurn
C

    • Clarence

      2024-01-24
      Loosen and adjust the laser head
The quick way is to get tap on the very bottom hole and shoot a short test shot so that it only makes a very thin hole, take off tape and see in which direction laser head should be adjusted.
        See translation
        Reply
      Relevant recommendations
      Collect
      Report