chanelink logo
CHANELINK
English

G code error,Problem with engraving a photo

Categories:
Laser
Tags:
693
1
See translation
2024-01-18

Problem with engraving a photo, laser starts in lightburn software and then freezes, don’t know where to look for the cause. Anyone have some idea? Photo of error

LightBurn

LightBurn
C

    • Liam

      2024-01-19
      Disable Gcode Clustering
AS far as i know Neje does not support it
Should fix the issue
Also, does your NEJE have Z axis (up and down)? If not, disable those as well (top right corner)
        See translation
        Reply
      Relevant recommendations
      Collect
      Report