chanelink logo
CHANELINK
English

Lines don’t stay together when I “trim line”

Categories:
Laser
Tags:
727
1
See translation
2023-11-28

I intend to cut two lines to transform the two areas into one. When I do “trim line” the line n stays in one. Then it creates open part problems. Does anyone know a way to not have to see each zone to manually join these points that don’t stay together?

LightBurn

LightBurn

LightBurn
C

    • roy

      2023-11-29
      Just grab the line end point (the green square) and drag it to another one that you want to connect it with. LightBurn has no idea what you intend by trimming, so it doesn’t automatically join things back up.
        See translation
        Reply
      Relevant recommendations
      Collect
      Report