chanelink logo
CHANELINK
English

How to make and cut a straight line with Lightburn

Categories:
Laser
Tags:
454
1
See translation
2023-08-17

I am just starting to use Lightburn software and it is not as friendly as it seems when I watch the hours for videos.

I am trying to cut the corner off of a piece of wood.
I just the pencil to draw a straight line then use the same settings as I did with a rectangle key chain.
But, the laser just lightly scores the wood and will not slow and cut.
What am I doing wrong?
thanks,
C

    • Robert Evans

      2023-08-21
      It’s because the work area of the S9 is 410x400mm (in reality it’s even a bit less). I would recommend not going above 395x395.
        See translation
        Reply
      Relevant recommendations
      Collect
      Report