Why does LB break up lines into 2mm segments in gcode?
Categories:
Laser
1K
1
0
2023-07-05
C
John Trant
2023-07-06Assuming you don’t have perforation mode or tabs/bridges on I assume this is due to a setting on Smoothieware devices. Check if you have “Reduce Smoothieware pause delay” enabled. Disable this and retest to see if that changes the behavior.
0Reply
Relevant recommendations
- 2023-06-15
- 2023-01-14
- 2023-05-20
- 2022-10-28
