How to swap X and Y axis
Categories:
Laser
665
1
0
2023-03-31
C
Liam
2023-04-01Likely, yes. But this is not just a simple configuration change within LightBurn. Assuming your machine allows GRBL configuration changes you’d have to do swap the wiring to the stepper motors and then make the GRBL configuration changes to adjust for that. If you also want to change homing location then you would potentially also change location and wiring of limit switches.
0Reply
Relevant recommendations
-
What is markparam.lib?
1 Reply2023-04-19 -
DS3 Fiber Coupled Diode Laser System
0 Replies06-12 - 2022-08-17