chanelink logo
CHANELINK
English

Cloudray 80W 115/230V MYJG

Categories:
控制
Tags:
911
1
See translation
2023-03-06

I have been trying to find out if there is a way to turn down the power supply to match my tube. I did a ramp test and my tube is rated to max out at 26ma but the controller is only at 70%. I want to make 26ma 100% so no one over drivers the tube. Is this possible?

 

 
C

    • Darren

      2023-03-07
      Most of these lps have an internal adjustment for current limiting. On mine, you have to be a contortionist to reach the adjustment…
This is mine, viewed from the rear, the Ruida machine console it at the far back top of the photo…

I was advised on mine to set a 50% pwm signal and adjust the current to 50% of maximum you wish to run.
Once adjusted, it will produce 50% current with a 50% power level setting in the software.
My maximum was specified at 21mA, so I set 50% pwm for 10.5mA…
Good luck
      See translation
      Reply
    Relevant recommendations
    Collect
    Report