繁体中文

French research team successfully develops new orange laser

918
2025-03-04 15:16:08
查看翻譯

A research team in France has reported a novel laser that emits light in the orange region of the spectrum, indicating its potential applications in flow cytometry and astronomical laser guidance.

In the research results just published in Optics Express, the team (including researchers from the É cole Polytechnique in Caen, France and Oxxius, a laser manufacturer based in Lannion) claimed that the samarium doped light source can output 23.9mW of power in continuous wave operation at a wavelength of 605nm.

We report the first visible light orange samarium laser directly pumped by a blue 465nm gallium nitride semiconductor laser diode. Our work represents the principle verification of compact low threshold semiconductor pumped orange and red samarium lasers


Figure 1: Layout of Sm: LiYF4 laser. The figure shows pump configurations 1 to 3, λ/2-AR coated half wave plate, FL focusing lens, CL collimating lens, N.A. numerical aperture. Source: Jonathan Demaimay, Pavel Loiko, Esrom Kifle et al., "Dior pumped orange Sm: LiYF4 lasers emitting at 605 nm", 《Optics Express》(2025).

 



Figure 2: Spatial characteristics of pump radiation from different blue light sources used for pumping Sm: LiYF4 laser: Figure 2: Spatial mode profile measured at the beam waist (at full power); The following figure shows the evaluation of the corresponding beam quality parameter M2. Source: Jonathan Demaimay, Pavel Loiko, Esrom Kifle et al., "Dior pumped orange Sm: LiYF4 lasers emitting at 605 nm", 《Optics Express》(2025).

Enter Orange
The paper states that laser emission with an orange wavelength (defined as 590-625nm) is of great significance in flow cytometry, as it can use fluorescent probes with a wider range and higher efficiency.

Other important applications include astronomy, where laser guided stars with a wavelength of 589nm are now routinely used in conjunction with adaptive optics systems to correct atmospheric distortions. Due to the absorption band at 603nm, ozone gas detection is also possible.

However, obtaining orange wavelengths using solid-state materials is difficult, especially when combined with strong continuous wave emission, high beam quality, and linear polarization.

Braun and colleagues reported that several methods are currently being studied to address this challenge, such as using complex crystal combinations in Raman laser design or using semiconductor disc lasers with frequency doubling. Another method is to use crystals doped with certain rare earth ions (especially praseodymium or samarium), which can directly emit orange spectra without frequency conversion.

The research team pointed out in the paper that "recent progress in developing blue gallium nitride laser diodes has promoted their use as pump sources and opened up new paradigms for compact, continuous wave, and efficient laser sources that do not require nonlinear optical components.

Figure 3: The red and orange spectral ranges of Sm: LiYF4 laser. Source: Jonathan Demaimay, Pavel Loiko, Esrom Kifle et al., "Dior pumped orange Sm: LiYF4 lasers emitting at 605 nm", 《Optics Express》(2025).

Figure 4: GaN semiconductor pumped Sm: LiYF4 laser: (a) input-output correlation and (b) typical laser emission spectra obtained from fiber coupled diodes and free space diodes under different output coupling rates TOC conditions, with η - slope efficiency and Pth - laser threshold. Source: Jonathan Demaimay, Pavel Loiko, Esrom Kifle et al., "Dior pumped orange Sm: LiYF4 lasers emitting at 605 nm", 《Optics Express》(2025).

Crystal selection
Although samarium doped lasers are not a new concept and red emission sources were developed as early as 1979, the latest work uses lithium yttrium fluoride (LiYF4) crystals, which have better thermal performance, higher optical quality, and lower production costs compared to alternative designs reported so far.

Figure 5: Photos of 1.1 at.% Sm: LiYF4 ingots grown under (a) natural light and (b) ultraviolet lamp irradiation. Source: Jonathan Demaimay, Pavel Loiko, Esrom Kifle et al., "Dior pumped orange Sm: LiYF4 lasers emitting at 605 nm", 《Optics Express》(2025).

The research team stated, "In this study, we reported the polarization spectra and first laser operation of Sm3+doped LiYF4 crystals in the orange (605nm wavelength) and red (648nm wavelength) bands, as well as the first semiconductor pumped visible samarium laser


Figure 6: Spectral diagram of Sm3+ions in LiYF4 crystal. Source: Jonathan Demaimay, Pavel Loiko, Esrom Kifle et al., "Dior pumped orange Sm: LiYF4 lasers emitting at 605 nm", 《Optics Express》(2025).

The research team believes that by carefully selecting the concentration of samarium ion doping, the efficiency of the laser can be further improved, while longer crystals can increase output power.

They concluded, "Considering the positive thermal lens in the a-cut LiYF4 crystal, we envisioned a compact (microchip type) semiconductor pumped Sm: LiYF4 laser that reduces cavity losses by bonding cavity components.

Source: Yangtze River Delta Laser Alliance

相關推薦
  • The new Casiris H6 4K UST tricolor laser projector is about to be launched through Indiegogo

    Casir is about to launch the H6 4K UST tricolor laser projector through Indiegogo. The new laser projector has a brightness of up to 3000 ANSI lumens and a BT.2020 color gamut coverage of 110%. It is an ultra short focus projector that runs on Android TV.The Casiris H6 4K UST tricolor laser projector is a brighter and more accurate version of the Casiris A6. It also has greater image projection ca...

    2023-09-18
    查看翻譯
  • Laser printing on fallen leaves can produce sensors for medical and laboratory use

    The manufacturing of sensors through 3D printing combines speed, design freedom, and the possibility of using waste as a substrate. In the circular economy model, various results have been achieved, and typically discarded residues are used as low-cost resources. A research team in Brazil has proposed a highly creative solution that involves printing electrochemical sensors on fallen leaves. The t...

    2024-05-16
    查看翻譯
  • Preparation of all silicon dielectric metasurface by femtosecond laser modification combined with wet etching, achieving ideal compatibility with complementary metal oxide semiconductor technology

    The fully dielectric element surface has the characteristics of low material loss and strong field localization, making it very suitable for manipulating electromagnetic waves at the nanoscale. Especially the surface of all silicon dielectric elements can achieve ideal compatibility with complementary metal oxide semiconductor technology, making it an ideal choice for large-scale monolithic integr...

    2023-10-23
    查看翻譯
  • The role of PTFE in laser processing

    Polytetrafluoroethylene (PTFE) has improved the efficiency and repeatability of nanosecond and picosecond laser processing technologies used in microelectronics and display glass manufacturing. In the field of precision manufacturing, the demand for efficient and repeatable processes is crucial. The laser structure of glass and laser ablation of silicon substrates are key areas where precision p...

    2024-07-26
    查看翻譯
  • Hanbit Laser Layout in Southeast Asia's Mid to Low End Market

    Hanbit Laser, a South Korean laser equipment manufacturer, has recently completed an important step in its strategic layout for the Southeast Asian market. Recently, the company officially opened a laser application center in Hanoi, Vietnam, and entered the local mid to low price equipment market by integrating laser technology and automation solutions. This is a substantial progress in implementi...

    02-26
    查看翻譯