My CO2 visual cutting machine uses the RDV6332M control system. When I adjust the camera exposure and gain parameters, the operation response is significantly slow. Every time I adjust the parameters,...

• camera
• CO₂ visual cutting
• RDV6332M
• control system
• RuiDa

When I was debugging the device, the RDC6685U controller frequently prompted the "distance limit" alarm. Whenever the machining axis moves to a specific position, the system automatically limits and i...

• camera
• RDC6685U
• control system
• RuiDa

My device is using the RDV6332M control system, and I was about to perform visual positioning, but I found that the camera lighting was never on. Whether switching the light source switch in the softw...

• camera
• CO₂ visual cutting
• RDV6332M
• control system
• RuiDa

When I was calibrating using the RDC6555G control system, I noticed the screen suddenly split into two halves. The upper part displayed the image normally, while the lower part showed the same image a...

• camera
• RDC6555G
• control system
• RuiDa

My CO2 vision cutting equipment is paired with the RDV6445G control system. During vision positioning, I've encountered instances where mark points are either misidentified or not recognized at all. A...

• camera
• CO₂ visual cutting
• RDV6445G
• control system
• RuiDa

I was using the RDD6584G vibration knife control system for Mark visual positioning machining when I started the equipment and loaded the machining file, preparing for visual positioning cutting. When...

• camera
• RDD6584G
• RuiDa

Hey guys, I have a Chinese CO₂ laser cutter with a conveyor axis. It’s currently running a Ruida RDV6442G-B(EC) controller and has an SV300 camera. At a trade show I saw very similar machines using ...

• camera
• RuiDa

My device is using Ruida's control system RDC6445GZ-DFM-RD, but I found that the network camera cannot display images. I connected the network camera and confirmed that all hardware connections are wo...

• camera
• CO₂ visual cutting
• RDC6445GZ-DFM-RD
• control system
• RuiDa

The control system used for my CO2 visual cutting equipment is RDC6612U-DFM. When I conducted a matching test, I found that the material could not be recognized. Is it a problem with the sensor? Or is...

• camera
• CO₂ visual cutting
• RDC6612U
• control system
• RuiDa

My CO2 vision cutting machine uses the RDV6445G controller. Today, when I was debugging, I found that the system could not recognize the device properly after connecting the camera through the USB int...

• camera
• USB
• CO₂ visual cutting
• RDV6445G
• RuiDa

Hello everyone! My CO2 visual cutting machine uses the RDC6685U control system, and in order to achieve accurate images, I specially performed cross correction. The parameters on the screen look norma...

• camera
• CO₂ visual cutting
• RDC6685U
• control system
• RuiDa

As described in my title, when using DVisionWorks for image processing, I plan to adjust the image parameters through manual correction function to achieve more accurate visual effects. How should I p...

• camera
• RDVisionWorks
• RuiDa

I encountered a problem while using the RDV6445G controller for visual processing. The system has recognized the R100 camera, but the screen still cannot be displayed after entering the visual interfa...

• camera
• CO₂ visual cutting
• RDV6445G
• control system
• RuiDa