If a laser type that does not match your actual use is selected in RDWorksV8, the controller may mistakenly send a start signal when turning on, causing the laser to automatically emit light.
0
回复
When RDWorksV8 is turned on, the laser always emits light
When starting RDWorksV8 software, the system encountered an abnormal phenomenon: the laser equipment often automatically emits light after startup without any operation instructions. Although the device displays normally, the laser needs to be manually turned off every time it is turned on. This issue must be resolved. Thank you for any suggestions!
你能回答这个问题吗？
请写下你的答案，帮助遇到同样问题的用户。
回答（2）
This post should be helpful to you, you can refer to:
0回复