My Ruida RDC6445S controller (firmware version RDC6445S-V26.01.19) does not respond to the Air Assist switch command enabled in LightBurn. However, the solenoid valve operates normally when connected directly to a 24V power supply, indicating that the valve itself is functional.
你能回答这个问题吗？
请写下你的答案，帮助遇到同样问题的用户。
I ran into the same issue, and here's what fixed it for me:
Navigate to Manufactory Settings (default password: RD8888), then go to Machine Config and set the "If blowing" parameter to "Yes."
After that, the WIND pin switches to "Ground" whenever the layer's air assist is active, allowing the solenoid to open the airflow as intended.
有类似问题但找不到解决方案？发布你的问题，社区用户会来帮你！
Copyright © 2021 Shenzhen Chanelink Network Technology Co., Ltd. All Rights Reserved.
