64E0A84B
已采纳回答
已采纳回答I suggest recalibrating the step spacing and verifying if there are any deviations. The software layer parameters can be used to compensate and optimize the seam width.
1
回复
RDWorksV8， Error occurred when using the brush function
When I use RDWorksV8 for processing, the laser cutting function performs normally, and the finished product size is consistent with the design drawing. However, when switching to the brush function for drawing, significant errors gradually appear, with line positions deviating from the original image. Any suggestions? esteem it a favor!
你能回答这个问题吗？
请写下你的答案，帮助遇到同样问题的用户。
回答（2）
This may be due to improper software parameter settings, inaccurate line width, scaling ratio, or resolution settings of the brush tool, which can result in actual drawing not matching expectations. Suggest checking if the unit settings (mm/inch), graphic scaling ratio, and pen tip width are correct.
1回复
thanks