My RDC6612U control system has encountered a new issue. As usual, when I select the processing file, the screen first displays "Reading" normally, and the progress bar slowly advances. However, after about 30 seconds, the interface suddenly stopped responding, followed by a prompt of "communication failure". I tried restarting the device, but the problem still didn't get resolved. Do you have any ideas? Thanks in advance!
Bu soruyu cevaplayabilir misiniz?
Lütfen bu soruya sahip olanlara yardımcı olmak için cevabınızı yazın.
Kabul Edilen CevapCheck the following two items:
1. Is the communication cable between the panel and motherboard working properly, and are the ports securely plugged in.
2. Whether the panel and motherboard product models match (model, firmware, non-standard).
There are many possibilities. For example, the file being read may be damaged or too large. If it is being read through a USB flash drive, there may be a problem with the quality of the drive or compatibility issues.
It could also be due to the controller's memory being full or a faulty motherboard
Is your file too large, which may cause read exceptions? You can test a small file first
Benzer bir sorunuz var ama çözüm bulamıyor musunuz? Kendi sorunuzu paylaşın ve topluluktan yardım alın.
Copyright © 2021 Shenzhen Chanelink Network Technology Co., Ltd. All Rights Reserved.
After replacing the communication cable, the problem still exists. After reading the motherboard information, I found that the model does not match. I replaced the corresponding panel to restore normal operation. Thank you for your help