Capacitive Sensor Signal Abnormality, Encoder or Servo System Fault, Electrical Interference and Poor Grounding, Parameter Setting Issues
0
Yanıtla
What factors cause the RDC6563FG control system's tracking alarm?
Hello! I am operating the device and the control system is RUIDA's RDC6563FG. When I was about to start processing, a warning popped up on the system interface, indicating that the status of the follower axis was abnormal. The machine briefly stopped, and the laser head seemed unable to follow the motion trajectory properly. What are the general reasons for this situation?
Bu soruyu cevaplayabilir misiniz?
Lütfen bu soruya sahip olanlara yardımcı olmak için cevabınızı yazın.
Cevaplar (2)
Usually caused by collision alarm, limit triggering, decreased capacitance value, excessive tracking error, etc
0Yanıtla