7760F7A1
Kabul Edilen Cevap
Kabul Edilen CevapCheck if the limit switch is broken, this is the most direct cause.
4
Yanıtla
There is an issue with the X/Y axis during the power-on reset of RDC6445G
I have a CO2 laser cutting system equipped with an RDC6445G control system. During the power-on reset, I noticed an unusual situation: the X-axis quickly hit the limit switch and stopped during movement, while the Y-axis continued to move towards the origin at a very slow speed, far from completing the reset. I really don't understand why this is happening. Can anyone help me? Thanks in advance!
Bu soruyu cevaplayabilir misiniz?
Lütfen bu soruya sahip olanlara yardımcı olmak için cevabınızı yazın.
The limit switch was faulty, and I replaced it with a new one. Thank you