My co2 cutting machine has been upgraded with the Ruida control system, model RDC8445S. When I press the reset button, there is no response. What could be causing this? Help!
Bu soruyu cevaplayabilir misiniz?
Lütfen bu soruya sahip olanlara yardımcı olmak için cevabınızı yazın.
Kabul Edilen CevapI suggest you check the following items:
1. The software manufacturer's parameter for enabling motor reset is not activated
2. The panel button function is damaged
3. User parameter power-on reset is not enabled
First, inspect the button itself for any damage, wear, spring failure, or stuck internal mechanical structure. Then, check the wiring for correctness.
These are all correct, the reason is that the power on reset enable was not turned on
Benzer bir sorunuz var ama çözüm bulamıyor musunuz? Kendi sorunuzu paylaşın ve topluluktan yardım alın.
Copyright © 2021 Shenzhen Chanelink Network Technology Co., Ltd. All Rights Reserved.
The reason is that the power on reset enable was not turned on, but after it was turned on, the panel can now be used normally