Spark
Kabul Edilen Cevap
Kabul Edilen CevapIt is likely that the machine's origin is set incorrectly, and the double cantilever origin can only be located in the upper left and lower left.
1
Yanıtla
RDC6612U controller, cutting graphics opposite to software display
Hello everyone! My device is equipped with the RDC6612U control system, but I found that the cutting result is in the opposite direction of the graphics displayed in the software. Is this a coordinate orientation issue? Or is it a communication parameter issue between the software and the controller? Thank you in advance for any suggestions.
Bu soruyu cevaplayabilir misiniz?
Lütfen bu soruya sahip olanlara yardımcı olmak için cevabınızı yazın.
